Dell Catalyst 3130 Command Reference Manual page 528

show env
Examples This is an example of output from the show env all command on a standalone switch:
Switch> show env all
This is an example of output from the show env stack command:
Switch> show env stack
SWITCH: 1
FAN is OK
TEMPERATURE is OK
Temperature Value: 33 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 65 Degree Celsius
Red Threshold
POWER is OK
RPS is AVAILABLE
<output truncated>
This example shows how to display information about stack member 3 from the master switch:
Switch> show env stack 3
SWITCH: 3
FAN is OK
TEMPERATURE is OK
Temperature Value: 33 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 65 Degree Celsius
Red Threshold
POWER is OK
RPS is AVAILABLE
This example shows how to display the temperature value, state, and the threshold values on a standalone
switch.
Switch> show env temperature status
Table 2-25
State
Green
Yellow
Red
Cisco Catalyst Blade Switch 3120 for HP Command Reference
2-498
: 75 Degree Celsius
: 75 Degree Celsius
Table 2-25 describes the temperature states in the command output.
States in the show env temperature status Command Output
Description
The switch temperature is in the normal operating range.
The temperature is in the warning range. You should check the external temperature
around the switch.
The temperature is in the critical range. The switch might not run properly if the
temperature is in this range.
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
OL-12248-03