Table of Contents
Advertisement
Appendix B
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform udld
Use the debug platform udld privileged EXEC command to enable debugging of the
platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command
to disable debugging.
Syntax Description
all
error
rpc {events | messages}
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History
Release
12.2(40)EX1
Usage Guidelines
The undebug platform udld command is the same as the no debug platform udld command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Command
show debugging
OL-13271-03
debug platform udld [all | error | rpc {events | messages}]
no debug platform udld [all | error | rpc {events | messages}]
(Optional) Display all UDLD debug messages.
(Optional) Display error condition debug messages.
(Optional) Display UDLD remote procedure call (RPC) debug messages.
The keywords have these meanings:
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
events—Display UDLD RPC events.
•
messages—Display UDLD RPC messages.
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
debug platform udld
B-69
Advertisement
Table of Contents
