Dell Catalyst 3130 Command Reference Manual page 669

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
This is an example of output from the show nmsp capability command:
Switch# show nmsp capability
NMSP Switch Capability
------------------------------
Service
-----------
Attachment
Location
This is an example of output from the show nmsp notification interval command:
Switch# show nmsp notification interval
NMSP Notification Intervals
----------------------------------
Attachment notify interval: 30 sec (default)
Location notify interval: 30 sec (default)
This is an example of output from the show nmsp statistics connection and show nmsp statistics
summary commands:
Switch# show nmsp statistics connection
NMSP Connection Counters
----------------------------------
Connection 1:
Connection status: UP
Freed connection: 0
Tx message count
-----------------------
Subscr Resp: 1
Capa Notif: 1
Atta Resp: 1
Atta Notif: 0
Loc Resp: 1
Loc Notif: 0
Unsupported msg: 0
Switch# show nmsp statistics summary
NMSP Global Counters
----------------------------
Send too big msg: 0
Failed socket write: 0
Partial socket write: 0
Socket write would block: 0
Failed socket read: 0
Socket read would block: 0
Transmit Q full: 0
Max Location Notify Msg: 0
Max Attachment Notify Msg: 0
Max Tx Q Size: 0
This is an example of output from the show nmsp status command:
Switch# show nmsp status
NMSP Status
----------------
NMSP: enabled
MSE IP Address
172.19.35.109
OL-12248-03
Subservice
--------------
Wired Station
Subscription
Rx message count
-----------------------
Subscr Req: 1
Capa Notif: 1
Atta Req: 1
Loc Req: 1
TxEchoResp RxEchoReq TxData RxData
5 5 4 4
Cisco Catalyst Blade Switch 3120 for HP Command Reference
show nmsp
2-639