Debug Ip Verify Source Packet - Dell Catalyst 3130 Command Reference Manual

debug ip verify source packet

debug ip verify source packet
Use the debug ip verify source packet privileged EXEC command to enable debugging of IP source
guard. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug ip verify source packet command is the same as the no debug ip verify source packet
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-12
debug ip verify source packet
no debug ip verify source packet
Modification
This command was introduced.
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
Description
Displays information about the types of debugging that are
enabled.
OL-13271-03