Debug Eap - Dell Catalyst 3130 Command Reference Manual

debug eap

debug eap
Use the debug eap privileged EXEC command to enable debugging of the Extensible Authentication
Protocol (EAP) activity. Use the no form of this command to disable debugging.
Syntax Description
all
authenticator
errors
events
md5
packets
peer
sm
Command Default Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX1
Usage Guidelines The undebug dot1x command is the same as the no debug dot1x command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show eap
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
B-8
debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
no debug dot1x {all | authenticator | errors | events | md5 | packets | peer | sm}
Display all EAP debug messages.
Display authenticator debug messages.
Display EAP error debug messages.
Display EAP event debug messages.
Display EAP-MD5 debug messages.
Display EAP packet debug messages.
Display EAP peer debug messages.
Display EAP state-machine related-events debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays EAP registration and session information for the switch or for the
specified port.
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
OL-13271-03