Dot1X Auth-Fail Vlan - Cisco Catalyst 2960 Command Reference Manual

dot1x auth-fail vlan

dot1x auth-fail vlan
Use the dot1x auth-fail vlan interface configuration command to enable the restricted VLAN on a port.
To return to the default setting, use the no form of this command.
Syntax Description vlan-id
Defaults
No restricted VLAN is configured.
Command Modes Interface configuration
Command History Release
12.2(25)SED
Usage Guidelines You can configure a restricted VLAN on ports configured as follows:
•
•
You should enable re-authentication. The ports in restricted VLANs do not receive re-authentication
requests if it is disabled. To start the re-authentication process, the restricted VLAN must receive a
link-down event or an Extensible Authentication Protocol (EAP) logoff event from the port. If a host is
connected through a hub, the port might never receive a link-down event when that host is disconnected,
and, as a result, might not detect any new hosts until the next re-authentication attempt occurs.
If the supplicant fails authentication, the port is moved to a restricted VLAN, and an EAP success
message is sent to the supplicant. Because the supplicant is not notified of the actual authentication
failure, there might be confusion about this restricted network access. An EAP success message is sent
for these reasons:
•
•
A supplicant might cache an incorrect username and password combination after receiving an EAP
success message from the authenticator and re-use that information in every re-authentication. Until the
supplicant sends the correct username and password combination, the port remains in the restricted
VLAN.
Internal VLANs used for Layer 3 ports cannot be configured as restricted VLANs.
You cannot configure a VLAN to be both a restricted VLAN and a voice VLAN. If you do this, a syslog
message is generated.
Catalyst 2960 Switch Command Reference
2-74
dot1x auth-fail vlan vlan-id
no dot1x auth-fail vlan
Specify a VLAN in the range of 1 to 4094.
Modification
This command was introduced.
single-host (default) mode
auto mode for authorization
If the EAP success message is not sent, the supplicant tries to authenticate every 60 seconds (the
default) by sending an EAP-start message.
Some hosts (for example, devices running Windows XP) cannot implement DHCP until they receive
an EAP success message.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03