Debug Cluster - Cisco Catalyst 2960 Command Reference Manual

Appendix B Catalyst 2960 Switch Debug Commands

debug cluster

Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
Syntax Description discovery
events
extended
hsrp
http
ip [packet]
members
nat
neighbors
platform
snmp
vqpxy
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines This command is available only on the cluster command switch.
The undebug cluster command is the same as the no debug cluster command.
OL-8604-03
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| platform | snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | platform | snmp | vqpxy}
Display cluster discovery debug messages.
Display cluster event debug messages.
Display extended discovery debug messages.
Display the Hot Standby Router Protocol (HSRP) debug messages.
Display Hypertext Transfer Protocol (HTTP) debug messages.
Display IP or transport packet debug messages.
Display cluster member debug messages.
Display Network Address Translation (NAT) debug messages.
Display cluster neighbor debug messages.
Display platform-specific cluster debug messages.
Display Simple Network Management Protocol (SNMP) debug messages.
Display VLAN Query Protocol (VQP) proxy debug messages.
Modification
This command was introduced.
Catalyst 2960 Switch Command Reference
debug cluster
B-5