Cisco Catalyst 2960 Command Reference Manual page 72

clear port-security
This example shows how to remove all the dynamic secure addresses learned on a specific interface:
Switch# clear port-security dynamic interface gigabitethernet0/1
This example shows how to remove all the dynamic secure addresses from the address table:
Switch# clear port-security dynamic
You can verify that the information was deleted by entering the show port-security privileged EXEC
command.
Related Commands Command
switchport port-security
switchport port-security
mac-address mac-address
switchport port-security
value
show port-security
Catalyst 2960 Switch Command Reference
2-46
Description
Enables port security on an interface.
Configures secure MAC addresses.
maximum Configures a maximum number of secure MAC addresses on a
secure interface.
Displays the port security settings defined for an interface or for
the switch.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03