Switch# Configure Terminal; Switch(Config-If-Range)# Switchport Mode Access; Switch(Config-If-Range)# End - Cisco Catalyst 2960 Command Reference Manual

channel-group
For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the
software configuration guide for this release.
Examples This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10
to channel 5 with the PAgP mode desirable:
Switch# configure terminal
Switch(config)# interface range gigabitethernet0/1 -2
Switch(config-if-range)# switchport mode access
Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode desirable
Switch(config-if-range)# end
This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10
to channel 5 with the LACP mode active:

Switch# configure terminal

Switch(config)# interface range gigabitethernet0/1 -2

Switch(config-if-range)# switchport mode access

Switch(config-if-range)# switchport access vlan 10
Switch(config-if-range)# channel-group 5 mode active

Switch(config-if-range)# end

You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
channel-protocol
interface port-channel
show etherchannel
show lacp
show pagp
show running-config
Catalyst 2960 Switch Command Reference
2-28
Chapter 2
Description
Restricts the protocol used on a port to manage channeling.
Accesses or creates the port channel.
Displays EtherChannel information for a channel.
Displays LACP channel-group information.
Displays PAgP channel-group information.
Displays the current operating configuration. For syntax
information, select Cisco IOS Configuration Fundamentals
Command Reference, Release 12.2 > File Management
Commands > Configuration File Management Commands.
Catalyst 2960 Switch Cisco IOS Commands
OL-8604-03