Ip Dhcp Snooping Binding - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

ip dhcp snooping binding

Use the ip dhcp snooping binding privileged EXEC command to configure the DHCP snooping binding
database and to add binding entries to the database. Use the no form of this command to delete entries
from the binding database.
Syntax Description mac-address
vlan vlan-id
ip-address
interface interface-id
expiry seconds
Defaults No default database is defined.
Command Modes
Privileged EXEC
Command History Release
12.2(25)FX
Usage Guidelines
Use this command when you are testing or debugging the switch.
In the DHCP snooping binding database, each database entry, also referred to a binding, has an IP
address, an associated MAC address, the lease time (in hexadecimal format), the interface to which the
binding applies, and the VLAN to which the interface belongs. The database can have up to 8192
bindings.
Use the show ip dhcp snooping binding privileged EXEC command to display only the configured
bindings.
OL-8604-03
ip dhcp snooping binding mac-address vlan vlan-id ip-address interface interface-id expiry
seconds
no ip dhcp snooping binding mac-address vlan vlan-id ip-address interface interface-id
Specify a MAC address.
Specify a VLAN number. The range is 1 to 4094.
Specify an IP address.
Specify an interface on which to add or delete a binding entry.
Specify the interval (in seconds) after which the binding entry is no longer
valid. The range is 1 to 4294967295.
Modification
This command was introduced.
ip dhcp snooping binding
Catalyst 2960 Switch Command Reference
2-127