Editing Effects - Yamaha O1V96 Owner's Manual

Tip:
• After inserting effects to channels, adjust the MIX BALANCE parameter for the effects,
according to the purpose and effects type.
• Move the cursor to an empty IN or OUT parameter box and press the [ENTER] button.
The Patch Select window appears, which enables you to quickly select available signal paths.

Editing Effects

To edit effect programs recalled to the internal Effects processors 1–4, press the DISPLAY
ACCESS [EFFECT] button repeatedly until the Edit page for the effects processor you wish
to edit appears.
Effects processors 1–4 correspond to the following pages:
• Effects Processor 1.......FX1 Edit page
• Effects Processor 2.......FX2 Edit page
• Effects Processor 3.......FX3 Edit page
• Effects Processor 4.......FX4 Edit page
These Edit pages contain the following effect parameters.
1
2
3
4
5
A
EFFECT NAME
This parameter displays the name of the effect program currently used by the effects
processor.
B
TYPE
This parameter displays the type of effect program currently used by the effects proces-
sor. The I/O configuration of the effect program is displayed below this parameter.
C
Move the cursor to this parameter, then press [ENTER] to display the Library page for
the selected effects processor.
D
Move the cursor to this button, then press [ENTER] to display the Patch | Effect page,
which enables you to assign signals to the inputs and outputs of Effects processors 1–4.
E
MIX BALANCE
This parameter knob enables you to set the balance between wet and dry signals. When
the parameter is set to 0%, only the dry signal is heard. When set to 100%, only the wet
signal is heard. Turn on the BYPASS button to bypass the currently-selected effects pro-
cessor.
button
button
161
Editing Effects
7
6
01V96 Version 2—Owner's Manual
14