Yamaha O1V96 Owner's Manual page 139

6 To change the Surround Channel to Bus Out assignment, move the cursor
to the SURR/BUS SETUP button, then press [ENTER].
The DIO/Setup | Surr Bus page appears.
1
3
A
BUS1–BUS8
These parameters select channels to be assigned to the Bus Outs in 3-1, 5.1, and 6.1 Sur-
round modes.
B
INIT
These buttons reset the channel assignment to the default setting.
C
Surround LR to Stereo
When this check box is on, the left and right front signals of the surround channels are out-
put from the STEREO L & R connectors.
7 To change the assignment, move the cursor to the desired Bus parameter,
rotate the Parameter wheel to select a channel, then press [ENTER].
The channels are swapped between the selected Bus and the Bus to which the channel
assigned to the selected Bus was assigned previously.
Tip:
• Pressing the DISPLAY ACCESS [SETUP] button repeatedly also displays the Surr Bus page.
• Available Bus Outs vary depending on the Surround mode. For example, in 3-1 Surround
mode, Bus Outs 1–4 are available. In 5.1 Surround mode, Bus Outs 1–6 are available, and
in 6.1 Surround mode, Bus Outs 1–7 are available.
8 Depending on the selected Surround mode or applications, patch the Bus
Out signals to the outputs, ADAT OUT channels, or slot output channels.
Connect a playback device or MTR to the output connectors.
Setting Up and Selecting Surround Pan Modes
139
2
01V96 Version 2—Owner's Manual
12