Yamaha O1V96 Owner's Manual page 64

64
Chapter 5—Tutorial
3 Move the cursor to the 2L parameter box in the STEREO INPUT section,
rotate the Parameter wheel or press the [INC]/[DEC] buttons to select "2TD
L," then press [ENTER].
4 In the same way, move the cursor to the 2R parameter box in the STEREO
INPUT section, then select "2TD R."
The signals input at the 2TR IN DIGITAL connector are now routed to ST IN Channel 2 L
and R.
5 Use the ST IN [ST IN] button to select ST IN Channels 1 and 2.
The ST IN [ST IN] button selects an ST IN channel pair (ST
IN Channels 1 and 2 or 3 and 4) which you can control using
the buttons and controls in the ST IN section. The indicators
to the right of the button indicate which ST IN channels are
currently selected.
6 Turn off the [ON] button for ST IN Channel 2.
The button indicator turns off.
This [ON] button should be turned on only when you monitor the playback signal of the
master recorder.
Adjusting the Track Mix Balance
Follow the steps below to adjust the mix balance among Tracks 1–16 and process the signals
using the EQ, compressor and gate.
1 Make sure that Tracks 1–16 on the digital MTR are all disarmed and the
recorder is in a mode that enables you to monitor the track playback signals.
2 Press the LAYER [1–16] button, then turn off the [ON] buttons for Input
Channels 1–16.
3 Press the LAYER [17–32] button and make sure that the [ON] buttons for
Input Channels 17–32 are turned on.
4 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until the
Pan/Route | Rout17–STI page appears. On this page, make sure that the S
buttons for Input Channels 17–32 are turned on, and the 1–8 buttons are
turned off.
01V96 Version 2—Owner's Manual
Lights up.
ST IN