Creating A Custom Layer By Combining Channels (User Assignable Layer) - Yamaha O1V96 Owner's Manual

Creating a Custom Layer by Combining Channels (User Assignable Layer)

• SURR .............................Copies the surround pan settings.
• AUX................................Copies the Aux Send levels.
• AUX ON ........................Copies the on/off status of the Channel to Aux signals.
• EQ...................................Copies the EQ parameter values.
C
Display Brightness
This parameter sets the brightness of the LED indicators in the range of 1 through 4.
Creating a Custom Layer by Combining Channels (User
Assignable Layer)
If you set the Remote Layer target to "USER ASSIGNABLE," you can create a custom layer
by combining any 01V96 channels (excluding the Stereo Out). This custom layer is called
"User Assignable layer."
1 Press the DISPLAY ACCESS [DIO/SETUP] button repeatedly until the
DIO/Setup| Remote page appears.
2 Set the TARGET parameter to USER ASSIGNABLE, then press [ENTER].
A confirmation window appears.
3 Move the cursor to the YES button, then press [ENTER].
The 01V96 displays the page shown below.
1
4 Select the channels you wish to assign to the User Assignable layer using the
1–16 parameter boxes (
You can store up to four 16-channel setups in four banks by switching Banks 1–4 via the
BANK 1–4 buttons. If you press[ENTER] before selecting the channels to assign, you will
still be able to select the channels you wish to assign in the User CH Select window.
Tip: You can reset the assignment to default by moving the cursor to the CLEAR button and
pressing [ENTER].
5 Use the LAYER [REMOTE] button to assign or recall the User Assignable layer.
You can use the faders and [ON] buttons to control the assigned channels.
1
).
233
01V96 Version 2—Owner's Manual
19