Partition Settings; Changes Of Partition Configuration - Fujitsu PRIMEPOWER 1000 User Manual

CHAPTER 7 Partition Settings and Notes
7.2

Partition Settings

This section describes the procedure for setting up the partition.
1
Register the hostid.
2
Specify the necessary settings for the partitions.
3
Setup the Console Connection Unit.
4
Specify the necessary settings for the User LAN.
5
Install Solaris in each partition.
Hostids are preset before shipping. For the partition expansion, additional hostids will be
necessary for expanded partitions.
For details, see the Section 6.4, "How to Add or Remove Partitions," in "System Console
Software User's Guide."
7.3

Changes of Partition Configuration

This section describes how to modify the partitioned configuration. There are two ways to turn
on the main unit: a) and b).
a) Modify partitioned configuration by reboot or power-on/off operation
See the following manuals:
l "System Console Software User's Guide"
l "Partition Operation Guide"
"System Console Software User's Guide" is attached to the System Console Software. For the
"Partition Operation Guide," please ask to the sales representatives, or a certified service
engineer.
b) Modify partitioned configuration by Dynamic Reconfiguration (DR)
See the following manuals:
l "Dynamic Reconfiguration Architecture Guide"
l "Dynamic Reconfiguration User's Guide"
"Dynamic Reconfiguration Architecture Guide" is attached to the System Console Software, and
"Dynamic Reconfiguration User's Guide" is attached to the Enhanced Support Facility.
For details, see the Section 6.4, "How to Add or Remove Partitions," in "System Console
Software User's Guide."
66 C120-E093-04EN