Fujitsu PRIMEPOWER 1000 User Manual page 16

FOR SAFE OPERATION
This indicates a hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. This also indicates that damage to the
product or other property may occur if the user does not perform the procedure correctly.
Task
Normal operation Equipment damage
vi
Be sure to follow the precautions below when installing the
equipment. Otherwise the equipment may be damaged.
l Do not block the ventilation slits.
l Do not install the main unit where it will be exposed to sunlight or
heat sources.
l Do not install the main unit in dusty places or places where it will
be exposed to corrosive gases or sea breeze.
l Keep the main unit isolated from vibration. Install the main unit
on a level surface.
l Use a grounding cable of category three or greater in Japan.
Make sure that the AC power supply source of the main unit is
grounded with dedicated grounding cable. Otherwise the main
unit may malfunction.
l Do not run a cable under a unit or allow a cable to become taut.
Do not disconnect the power cable when the power is turned on.
l Do not place anything on top of the main unit. Do not use the
main unit as a work space.
l Avoid condensation in the main unit, do not raise the ambient
temperature rapidly in winter. Use the main unit only after it has
warmed up sufficiently.
l Do not install the main unit near a noise generating device such
as a photocopier, air conditioner, or welder.
l Take static electricity prevention measures. Note that some
carpets generate static electricity easily and can cause the main
unit to malfunction.
l When moving the main unit, do not pull on the front cover.
Otherwise the main unit may be damaged.
Data destruction
Before shutting down power, the following events must be
ensured, otherwise data may be destroyed.
l All applications have finished processing.
l No user is using the components.
If necessary, back up files before shutting down.
Data destruction
Never perform the following operations if the partition is running
normally:
l Partition dump switch instruction
l Partition reset instruction
l Forcible partition termination instruction
Warning Page
10
20
39
C120-E093-04EN