Fujitsu PRIMEPOWER 1000 User Manual page 17

Task
Normal operation Data destruction
C120-E093-04EN
Do not disconnect the power cable from the AC inlet while the
power is on. Data on the disk may be destroyed.
Data destruction
Except in an emergency, never turn off the main switch while the
power is on. Data on the disk may be destroyed.
Equipment damage
Be sure to follow the precautions below when installing the
equipment. Otherwise the equipment may be damaged.
l Because this unit is installed in a closed or multi-unit rack
assembly, the operating ambient temperature inside of the rack
environment may be greater than room ambient. Therefore,
consideration should be given to installing the unit in an
environment compatible with the manufacturer's maximum rated
ambient temperature. Consideration for adjustment of air
condition like air circulation should be given to prevent the
internal rack ambient from exceeding the maximum operating
ambient temperature of this unit; 35 C (95 F).
l Installation of the file unit in a rack should be such that the
amount of air flow required for safe operation of the unit is not
compromised. Therefore, this unit has ventilation openings at
front and rear face of the unit. Do not cover or close these
ventilation openings to prevent overheating.
l Weight of this unit with maximum configuration: 30 kg (66 lb). Be
careful to avoid injury during installation of this unit into the rack.
l If the unit is powered from a Power strip or a Service outlet
located in other units, it may overload the Power supply cord of
the Power strip or the other units. Confirm that the current rating
of Power strip or Service outlet exceeds the combined ratings of
all the equipment it is supplying. Electrical ratings of this unit:
Rated 100 - 240 V AC, 3.0 - 1.5 A, 50/60 Hz, single phase.
Reliable grounding of rack-mounted equipment is required.
Equipment damage, Data destruction
Be sure to follow the precautions described below when handling
a disk drive. Otherwise the disk drive may be damaged or cause
loss of data.
l Avoid heavy impact to the unit.
l Keep the disk drive unit isolated from a magnetic field generating
device such as a motor, or audio-speaker.
l Avoid condensation in the disk drive, do not install the disk drive
where condensation may occur, or temperature and humidity
may change rapidly.
Warning
FOR SAFE OPERATION
Page
92
92
93
96
vii