Fujitsu PRIMEPOWER 1000 User Manual page 108

CHAPTER 9 System Management Console (SMC)
6
When a prompt appears, enter the command below to confirm the controller
number ("c0" in c0t0d0) of the disk of the system volume.
#format <Return>
Searching for disks...done
AVAILABLE DISK SELECTIONS:
Specify disk (enter its number):
After the controller number is confirmed, close the menu as instructed on the screen.
7
When a prompt appears, enter the command below to start the backup. For the
controller number, enter the number confirmed in Procedure 6.
SMC# dd if=/dev/rmt/0 of=/dev/rdsk/c0t0d0s2 bs=1024k <Return>
When entering the command above to restore, the value of buffer size (bs) option must be equal
to that used for backup.
The restoration process is complete when a prompt appears again.
(The 8G bytes disk drive requires about 2 hours to restore. Restoring of the disk drive takes
longer as its capacity increases.)
8
Press the Eject switch on the DAT unit to remove the data cassette.
9
Press the <STOP> + <A> keys to display the "ok" prompt.
10
Enter the command below to reboot.
ok boot <Return>
Daily work can be restarted when the Login screen of System Console Software appears.
Remove the Solaris 7 CD-ROM.
11
If necessary, restore the setup data for the System Console Software. For the
restoration procedure, see the
Software Setup Data."
80
0. c0t0d0 <sfdsk type1.0; ST320420A cyl 39533 alt 2 hd 16 sec 63>
/pci@1f,0/pci@1,1/ide@3/dad@0,0
Section 9.3.4, "Restoring the System Console
Confirm this number.
C120-E093-04EN