CHAPTER 5 Main Unit Operator Panel Operation
Command
Reset
(Reset)
Request
(Req.)
Up
(Up)
Server ID
Segment ID
Altitude
Through the execution of "Reset," "Req.," and "Up" command, the main unit behaves as
follows:
Reset: Compulsorily resets partitions and restarts.
Req. : Acquires OS dump of the selected partition and enters OS panic state. The partition
restarts automatically after the OS panic.
Up : Starts selected partitions.
Each command may be disabled depending on the state of the Mode switch.
Table 5.4
Table 5.4 Partition Event Transmission by the Mode Switch
Event
Reset
Req.
Up
42
Table 5.3 Command List
Symbol
Partitions (0 to e)
None
(displays execution
confirmation message)
None
(displays execution
confirmation message)
None
(displays execution
confirmation message)
Setup (S)
Enter a numeric value
Enter a numeric value
Enter a numeric value
Increments: 500 m
(1640 ft)
lists combination of enable/disable and the Mode switch state.
LOCK
Disabled
Disabled
Enabled
Parameter
Reset request
Resets selected partition
OS dump request
Sends a request event for
acquiring OS dump of the
selected partition.
Start-up request
Activates the selected
partition.
Sets the Server ID assigned to
the main unit.
Sets the Segment ID to which
the main unit belongs to.
Sets the altitude from the sea
level where the main unit is
installed.
Mode switch
UNLOCK
Disabled
Enabled
Enabled
Functional outline
MAINTENANCE
Enabled
Enabled
Enabled
C120-E093-04EN