Fujitsu PRIMEPOWER 1000 User Manual page 113

• boot-file
Sets a boot file. This setting is enabled when the value of diag-switch? in the OBP environment
is set to false.
• scsi-initiator
Set the host side address of SCSI bus. Range is from 0 to 7. The default value is 7.
• local-mac-address?
If the value is true, the network driver uses its own MAC address. If the value is false, a MAC
address of the system is applied. The main unit applies the MAC address assigned to each
partition.
The default value is false.
• tty-conspath, tty-sub-conspath
tty-conspath shows which System Board serial ports in the partition are set to the console path.
The tty-sub-conspath shows which System Board serial ports in the partition are set to auxiliary
console path.
To fix the console path, set as described below:
"cXsY(X=the cabinet number, Y=the System Board number)"
Use one of the following values to set the cabinet number:
0: The cabinet having the panel (the Base cabinet)
1: The cabinet not having the panel (the System Expansion cabinet)
The following variables can be set:
none, c0s0, c0s1, ..., c0s7, c1s0, ..., c1s7
The default value is none.
If none is set, tty-conspath sets the System Board with the lowest slot number to the console
path. tty-sub-conspath sets the System Board of the slot number specified by tty-conspath in the
same partition plus 1 to the auxiliary console path.
• diag-level
max: Operate power-on diagnosis in maximum range. In this level, power-on diagnosis takes
time for starting up; therefore, do not set on this level in normal operation.
min: Operate normal power-on diagnosis (default setting).
off: DO NOT PERFORM POWER-ON DIAGNOSIS. In this level, the system may be down
due to failed components. Do not set in this level to prevent loss of data.
C120-E093-04EN
A.2 Other OBP Environment Variables
85