Preset Mode; Erasing A Preset - Wohler AMP1-E8DA User Manual

Preset Mode

This mode of operation is intended for situations where a number of
pre-defined unit configurations is all you need. This allows even the
most non-technical person to quickly scan through a list of sources to
monitor, without having to understand the operation of the rest of the
unit, or which source is plugged into which input of this unit.
In Preset
With
Input
signal type.
Note:
To enable or disable
1.
2.
3.
4.

Erasing a Preset

This menu command allows you to erase a stored preset. Pressing the
Enter
mode, the Input
Preset mode enabled, you can recall a preset by pressing only the
button to access each stored preset by name, rather than by
When this mode is enabled, you can no longer directly select
the inputs by the input type (e.g., AES 1, SDI 2, analog, and
so on). The inputs are accessed only indirectly through the
presets in this mode. To access the inputs by input type, you
must disable Preset
Preset
Press Fn+Setup .
Use the Up and Down
the LCD window and press
Note:
This selection will not appear if all the presets are
empty. In this case, you will need to store at least one
preset to enable this menu item.
Press the Up and Down
(disabled) and
Ena
setting, or press Escape
be returned to the Setup
Press Escape again to return to normal operation.
button will allow the user to choose a preset to erase.
© 2 0 1 1 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
button cycles through the defined presets.
mode first
mode:
arrow buttons until
Enter .
arrow buttons to toggle between
(enabled). Press Enter
to cancel the change. Either way, you will
menu.
8 2 1 0 1 6 :
C h a p t e r 6 Setup Menu
P r e s e t M o d e
appears in
PSet Mode
Disa
to accept the new
A M P x- E 8 S e r i e s U s e r G u i d e
63