C h a p t e r 5
D o l b y
D o l b y I n p u t S o u r c e S e l e c t i o n
Dolby Input Source Selection
Dolby Decoding
8 2 1 0 1 6 :
A M P x- E 8 S e r i e s U s er G u i d e
50
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
1.
Enter
Dolby Decode
2.
Press the
Input
enabled when it appears in the LCD screen.) Each press of the
Input
button cycles through each of the four selections:
•
BSt1 (Bitstream 1)
•
BSt2 (Bitstream 2)
•
SDI (not available in the DA model)
•
Auto.SDI
•
(signal is present and auto-detected)
SD.SDI
•
(signal is present and auto-detected)
HD.SDI
•
(signal is present and auto-detected)
3G.SDI
3.
If one of the SDI inputs is selected, pressing the
selects the de-embedded SDI pair to be decoded.
Figure 5–1
When you connect a valid bitstream containing at least one multi-
channel program (such as a 5.1 or 7.1 channel surround type) to the
AMPx-E8 Series unit, it enters a default multi-purpose monitoring
mode, the
Auto-Monitor Multi-Channel Mode
sends a downmix to the unit's speakers, this mode also allows you to
select pairs of channels from the multi-channel program in a Dolby
bitstream.
Note:
You can only enter this mode as described below; it cannot
be selected.
mode by pressing the
button to select the source. (The selection is
or
if no signal is present
Auto.SDI2
Dolby Input Source Selection
PG1
BSt1
Dolby
button.
Group
button
PG1
E
. While this mode initially