Setting The Monitor's Startup Configuration - Wohler AMP1-E8DA User Manual

Setting the Monitor's Startup
Configuration
You can configure the AMPx-E8 Series monitor to start up from a
powered-off state, and automatically begin monitoring a particular
input.
1.
2.
Figure 3–13
3.
4.
5.
6.
S e t t in g t h e M o n i to r ' s S ta r tu p C o n f i g u r at i o n
Press the Fn + Setup
Press the Down button until the LCD screens
in Figure 3–13 below.
Startup Menu Option
848131
Press the Enter button to display the
Press the or
Up Down
options. Note that only those options that are available in your
system will show up in the list.
• Last Used
• Analog
• AES 1
• AES 2
• SDI 1
• SDI 2
• BSt1
• BSt2
• SDI 1 + DBY
• SDI 2 + DBY
Press the Enter button to make your selection and return to the
Setup Menu .
Press the Escape button to return to normal operation.
© 2 0 1 1 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
C h a p t e r 3
buttons.
3.03
Setup: Startup
Startup
buttons to scroll through the startup
8 2 1 0 1 6 :
Audio Configuration
as shown
Startup
list.
A M P x- E 8 S e r i e s U s e r G u i d e
39