Left And Right - Wohler AMP1-E8DA User Manual

C h a p t e r 6 S e t u p M e n u
S a v in g a P r e s e t
Important:
Important:
8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s er G u i d e
62
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
3. Pressing the Enter
and returns the unit to normal operation.
This concludes the procedure for overwriting an existing preset with
the same name.
Pressing the Escape
name as shown in
Figure 6–9
4. Scroll through letters (and symbols) using the
buttons. Press the
in the display and move to the next letter. Repeat this procedure
until the display shows the name you want to use for this preset.
Note:
Pressing the
but the only one that changes will be the one
immediately to the left of the underscore. As a result, it
may be necessary to start the procedure over again if
too many characters appear in the display.
Naming will automatically end after you select eight characters, or
when you press the
display.
Note:
The
_DONE_
follows the lower case alphabet. The character order is
the order of ASCII characters.
After naming the preset, the current state of the system is saved
under that name and preset number, and the system returns to
normal operation.
This concludes the procedure for overwriting an existing preset with a
new name.
button keeps the old name for the new preset
button displays a prompt for a new preset
Figure 6–9 below.
Save New Name?
Studio ?@<A>BC
Name: A_
Enter button to accept the current letter shown
Enter button may display multiple letters,
Enter button when
selection comes before the numerals, and
Left and Right
appears on the
_DONE_