Creating A New Preset - Wohler AMP1-E8DA User Manual

C h a p t e r 6 S e t u p M e n u
S a v in g a P r e s e t

Creating a New Preset

8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s er G u i d e
60
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
Note:
To cancel the procedure at any time during this process,
press the
and the unit will return to normal operation.
1. Press either the
Unused.
Figure 6–4
2. Press the
Enter
as shown in Figure
Figure 6–5
3. Scroll through letters (and symbols) using the
buttons. Press the
in the display and move to the next letter. Repeat this procedure
until the display shows the name you want to use for this preset.
Note:
Pressing the
but the only one that changes will be the one
immediately to the left of the underscore. As a result, it
may be necessary to start the procedure over again if
too many characters appear in the display.
Figure 6–6
Escape button and the preset will not be saved
Up or Down buttons to choose any preset labeled
Choose an Unused Preset
Choose PresetNum
Preset7: Unused
button to display a prompt for a new preset name
6–5.
Assigning the Name of a Preset
AES 1 ?@<A>BC
Name: A_
Enter button to accept the current letter shown
Enter button may display multiple letters,
Completed Preset Name Selection
HD.SDI1 _DONE_
Name: HDSDI1

Left and Right
_