Overwriting An Existing Preset - Wohler AMP1-E8DA User Manual

Important: This concludes the procedure for creating a new preset.

Overwriting an Existing Preset

1.
Figure 6–7
2.
Figure 6–8
Naming will automatically end after you select eight characters, or
when you press the
display. See Figure 6–6
Note:
The
_DONE_
follows the lower case alphabet. The character order is
the order of ASCII characters.
After naming the preset, the current state of the system is saved
under that name and preset number, and the system returns to
normal operation.
Press either the Up or
not labeled Unused.
Choosing an already used preset will display a warning to the user
that they are about to overwrite the preset, as shown in
below.
Overwriting a Preset
OVERWRITE PRESET
Preset1: Off Air
Press the Enter button to display
on page 61) with the selected preset number and current name
below it. If you wish to use the name displayed, press
skip the rest of the following instructions. Your current settings are
now stored in the selected preset.
Save Old Name?
Preset3: Studio
© 2 0 1 1 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
button when
Enter
above.
selection comes before the numerals, and
Down buttons to choose any preset that is
Save Old Name?
Save Old Name?
8 2 1 0 1 6 :
C h a p t e r 6 Setup Menu
S a v i n g a P r e s e t
appears on the
_DONE_
Figure 6–4
(Figure 6–8
Enter
A M P x- E 8 S e r i e s U s e r G u i d e
, and
61