Analog Output Preference - Wohler AMP1-E8DA User Manual

C h a p t e r 3 A u d i o C o n f i g u r a ti o n
A n a l o g O u t p u t P re f e re n c e

Analog Output Preference

8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s er G u i d e
28
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
The Analog Output Preference determines how the
Downmix Analog Output
Output connector output the metered signals when either the DM1,
DM2, or DM3 downmix options are selected. Refer to
Connectors on page 14
The default setting is Downmix, which outputs the speaker assign with
individual channel scaling (gain settings) intact as determined by the
selected downmix. However, if you select Discrete, then all channels
with the downmix are output from these connectors at full gain without
scaling of the channels as determined by the selected downmix.
To change the analog output settings:
1. Hold the Fn button while pressing the
2. Press the Down
in Figure 3–1 below.
Figure 3–1
3. Pressing the
Enter
depending on the current setting.
Figure 3–2
Figure 3–3
connectors and the
for details.
button until the LCD screens
Analog Output Preference LCD screen
848131 3.03
Setup: AOut Pref
button displays either
Analog Output Preference Setting -
Discrete
-- Setup --
Aout Pref: Discr
Analog Output Preference Setting -
Downmix
-- Setup --
Aout Pref: D-mix
Selected/
Metered Analog
Rear Panel
Setup button.
as shown
AOutPref
Figure 3–2 or Figure 3–3