Single; Pairs - Wohler AMP1-E8DA User Manual

C h a p t e r 3 A u d i o C o n f i g u r a ti o n
M o n it o r in g a n d M ix in g M o d e s

Single

Pairs

8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s er G u i d e
30
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
This mode allows you to select one and only one signal for each speaker
independently of the other speaker and is most useful when you are
monitoring mono sources.
To select channels individually for each speaker:
1. Press the Fn + Single
Figure 3–5
2. Press the Left button to cycle through the channel selections for
the left speaker. Likewise, press the
the channel selections for the right speaker.
This mode allows you to quickly assign one pair of channels to the
speakers. The selections are limited to Channels 1-2, 3-4, 5-6, and 7-8.
In all cases, the odd channel is sent to the left speaker, and the even
channel to the right. This mode is most useful when you are monitoring
stereo sources.
To select channel pairs for each speaker:
1. Press the Fn + Pair
Figure 3–6
2. Use the Left Up
pair selections.
buttons to enable single channel selection.
Single Channel Selection
CH1 AES1
----
buttons to enable channel pair selection.
Channel Pair Selection
CH7 AES1
----
or Right Up buttons to cycle through the channel
CH2
Right button to cycle through
CH8