Enabling/Disabling Preset Mode; Recalling A Preset; Speaker Assign/Preset Buttons (Presets 1 Through 4 Only) - Wohler AMP1-E8DA User Manual

Note:

Enabling/Disabling Preset Mode

To enable or disable
1.
2.
3.
4.

Recalling a Preset

If
Preset
preset. Subsequent presses will cycle through all the available presets.
Speaker Assign/Preset Buttons (Presets 1 through
4 Only)
Presets 1 through 4 get special attention. You can recall, save, or
overwrite them simply by pressing
the corresponding
below the meters on the left side of the unit). In the following examples,
we'll be using Preset 1.
When this mode is enabled, you can no longer directly select
the inputs by the input type (e.g., AES 1, SDI 2, analog, and
so on). The inputs are accessed only indirectly through the
presets in this mode. To access the inputs by input type, you
must first disable
Preset
Press Fn+Setup .
Use the Up and Down
the LCD window and press
Note:
This selection will not appear if all the presets are
empty. In this case, you will need to store at least one
preset to enable this menu item.
Press the Up and Down
(disabled) and
Ena
setting, or press Escape
be returned to the Setup
Press Escape again to return to normal operation.
mode is enabled, press
Speaker Assign
© 2 0 1 1 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
M e t h o d s o f A c c e s s i n g t h e P r e s e t s
Preset mode.
mode:
arrow buttons until
Enter .
arrow buttons to toggle between
(enabled). Press Enter
to cancel the change. Either way, you will
menu.
to recall the first available
Input
Fn+Preset x
button immediately above or
8 2 1 0 1 6 :
C h a p t e r 4 Presets
appears in
PSet Mode
Disa
to accept the new
(where x represents
A M P x- E 8 S e r i e s U s e r G u i d e
45