Sdi Inputs; Selecting Sdi Groups And Subgroups; Dolby Decode Mode Disabled - Wohler AMP1-E8DA User Manual

•
Figure 3–10
2.

SDI Inputs

Selecting SDI Groups and Subgroups

Dolby Decode Mode Disabled

When you select either of the SDI inputs for monitoring while Dolby
Decode mode is disabled, the
two, four-channel SDI audio groups to display in the level meters.
When you press the buttons quickly, the selection order follows that
shown in
Right (+): Selected channels are in-phase (+1 correlation
maximum).
With typical stereo program material, the moving block display is
normal.
If the signals to the speakers are completely independent, they will
have a correlation result of 0, and the block will be stationary in the
center of the screen. See
Phase Correlation Display
-
A mono in-phase signal fed to both right and left speakers would
result in the block being in the right-most position indicating the left
and right speaker signals are phase-identical.
Press any button to return to normal operation.
Table 3–3 on page
© 2 0 1 1 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
C h a p t e r 3
Figure 3–10 below for an example.
Phase
Group button allows you to select which
36.
8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s e r G u i d e
Audio Configuration
S D I I n p u t s
+
35