Analog Output Preference Mode; Recalling A Preset - Wohler AMP1-E8DA User Manual

C h a p t e r 6 S e t u p M e n u
A n a l o g O u t p u t P re f e re n c e M o d e

Analog Output Preference Mode

Recalling a Preset

8 2 1 0 1 6 : A M P x- E 8 S e r i e s U s er G u i d e
58
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
To exit Setup Mode , press the
Note: The RCallSet, PSetMode, and
not be available if a preset has not been previously saved to
the unit. See
preset of the current unit configuration.
To change the Analog Output Preference
then press the Enter
This entry within the
Selected/Downmix Analog Out
connectors on the rear panel output the metered signal when any of the
DM1, DM2, or DM3 downmix selections is enabled.
The default setting is Downmix, which outputs the speaker assign with
individual channel scaling (gain settings) intact as determined by the
selected downmix (DM1, DM2, or DM3). In addition, the channels are
summed at unity gain into the speakers and headphones. However, if
is selected, then all channels within the downmix are output
Discrete
from these connectors at unity gain without scaling of the channels as
determined by the selected downmix. For example, the center channel
scaling is -3dB, and the surround channel scaling is set in the
menu.
1. Press the Fn + Setup
2. Press the Up button to display RCallPSet.
3. Press the Enter
Esc button.
Saving a Preset on page 59
button.
Setup menu is used to determine how the
and Metered Analog Out
button to display the
button to select this option.
options will
ErasePSet
for how to save a
, select
AOutputPref
Setup
Setup menu.
and