Table of Contents
Advertisement
C h a p t e r 2
S y s te m O v e rv i e w
F r o n t P a n e l C o n t r o l s
LCD Screen
8 2 1 0 1 6 :
A M P x- E 8 S e r i e s U s er G u i d e
10
© 2 0 1 1 Wo h l e r Tec h n o l o g i e s , I n c. A l l r i g h t s r e s er ve d .
control adjusts the brightness of the right four bar graphs.
Clockwise rotation increases the brightness.
Note:
The AMP1s only have one brightness control.
•
Speaker Assign LEDs (1 through 8, Left and Right): These LEDs
indicate the speaker mix of selected channels. The speaker assign
LEDs are located above each of the 53-segment bar graphs.
Note:
In the AMP1s, the speaker assign LEDs are the top
segment of the meters.
In addition, on the AMP1s, the top LED segment of each bar graph
serves as the speaker assign LED for the respective channel.
•
Speaker Assign/Preset Buttons (Speaker Assign, 1 through 8;
Preset Buttons, 1 through 4): Pressing any of these buttons selects
the channels to be summed into either or both speaker channels, or
to create and recall presets when used in conjunction with the
button. Refer to
Chapter 4 on page 43
presets.
The LCD screen displays various parameters and settings, and is also
used to configure/program the monitor. The features of the LCD
screen (shown in
Figure 2–3
•
Mix Status: Displayed on the top right and top left corners of the
LCD screen, the
Mix Status
is mixed to the internal speakers.
•
Source Status: Displayed in the top center of the LCD screen, the
Source Status
currently audible in the internal speakers. If a preset has been
recalled, this area displays the name of the preset until a monitoring
or input change is made.
•
SDI Groups/Dolby Signal Type: Displayed in the bottom left and
bottom right corners of the LCD screen, these groups indicate the
SDI channels that are currently mixed to the internal speakers. In
the case when a Dolby signal is mixed to the internal speakers, the
bottom left corner will be blank and the bottom right corner will
display the Dolby logo, PCM, DAT, or --- (no input signal).
through
Figure
indicates how the current input signal
indicates the current signal type and current input
for more information about
2–6) include:
FN
Hide quick links:
Advertisement
Table of Contents
