Crestron TPS-6X Series Operation Manual page 33

Crestron TPS-6X Series
Operations Guide – DOC. 6875C
"WIRELESS SETUP" Menu (Shown in Roaming Setup Configuration)
Up to eight CEN(I)-ERFGW-POE gateways can be acquired by a TPS-6X. To
acquire multiple gateways, put all the gateways in Acquire mode. Then follow the
steps below:
1. Select the appropriate gateway index by touching one of the buttons marked
GW 1 through GW 8 on the left side of the roaming setup menu.
2. Touch ACQUIRE START. Acquire progress is shown in the Acquire State
section of the menu. Once the TPS-6X finds a gateway, the acquire stops
automatically.
3. Repeat steps 1 and 2 until all gateways are acquired.
If using multiple TPS-6X touch screens, follow the steps above for each touch
screen.
NOTE: When multiple gateways are put in Acquire mode at the same time, the
TPS-6X saves the first available gateway in the selected gateway index. To save
gateways in a particular order on the list, put only one gateway in Acquire mode at a
time and perform the acquire process, selecting the required gateway index.
Gateways which are already acquired, are not acquired again, unless first removed
from the list, as shown on the following page.
For each acquired gateway in the list, the name and signal strength is shown on the
roaming setup menu. A small green indicator is displayed next to the signal strength
meter of the gateway to which the panel is currently connected.
Selected Gateway's UID, shown at the right side of the screen, indicates the currently
selected gateway's UID.
Touch See All GW UIDs to see the UIDs of all acquired gateways at once. The
screen looks like the illustration on the following page.
Isys 5.7" Wireless Touch Screens
Isys 5.7" Wireless Touch Screens: TPS-6X Series • 29