Crestron TPS-6X Series Operation Manual page 17

Crestron TPS-6X Series
Via the Trigger Keys
Via Crestron Toolbox
Operations Guide – DOC. 6875C
If a project is running, the MAIN MENU can be accessed using one of two methods:
via the trigger keys on the top of the touch screen or via Crestron Toolbox.
1. Press and hold the right trigger key on the top of the touch screen and at the
same time, touch the upper right corner of the screen.
2. Continue holding the right trigger key and touching the upper right corner
of the screen. At the same time, press and hold the left trigger key on the
top of the touch screen. After four seconds, the panel resets.
3. Once the screen turns black, release the left trigger key and the panel enters
the MAIN MENU, as shown in the illustration below.
4. Release the right trigger key and the touch screen.
1. Establish communication with the touch screen (refer to "Establishing
Communication" which starts on page 50 for details).
2. Right-click on the device and select Functions | Setup Mode....
Select Enter Setup Mode. The MAIN MENU is displayed, as shown in the
3.
illustration below.
NOTE: Select Exit Setup Mode to exit the setup menu.
The MAIN MENU displays four large buttons: Touch Screen Calibration, Exit
and Run Program, Setup and Diagnostics, as shown in the following illustration.
MAIN MENU
The Exit and Run Program button verifies that all of the setup information has
been saved to the EEPROM and displays the main page that has been programmed
into the system. The remaining buttons on the MAIN MENU open other menus and
screens which are discussed in subsequent paragraphs.
Isys 5.7" Wireless Touch Screens
Isys 5.7" Wireless Touch Screens: TPS-6X Series • 13