Crestron TPS-6X Series Operation Manual page 32

Isys 5.7" Wireless Touch Screens
28 • Isys 5.7" Wireless Touch Screens: TPS-6X Series
The manual configuration menu also has buttons to turn RF Roaming ON or OFF
and for ROAMING SETUP.
The TPS-6X can be used with multiple CEN(I)-ERFGW-POE gateways to create a
wireless roaming network.
NOTE: By default, roaming is disabled in both the TPS-6X and
CEN(I)-ERFGW-POE and must be enabled in both devices.
On the CEN(I)-ERFGW-POE, enable roaming by using the following procedure:
1. Open a text console for the gateway using the gateway's IP address.
2. Enter the command RFROAMING ON.
3. Enter the command REBOOT.
This procedure must be performed for each gateway used in the roaming setup. For
more information about roaming, refer to the latest version of the TPS-6X Roaming
Quickstart Guide (Doc. 6799).
To enable roaming in the TPS-6X, touch RF Roaming ON. A ROAMING SETUP
button appears.
When roaming is enabled, a ROAMING SETUP button also appears in place of the
ACQUIRE START button on the main "WIRELESS SETUP" menu.
"WIRELESS SETUP" Menu (Shown with Roaming Enabled)
From the manual configuration menu or the main "WIRELESS SETUP" menu,
touch ROAMING SETUP to enter the roaming setup menu shown on the following
page.
Crestron TPS-6X Series
Operations Guide – DOC. 6875C