Crestron TPS-6X Series Operation Manual page 31

Crestron TPS-6X Series
Operations Guide – DOC. 6875C
To check the quality of the link status, from the MAIN MENU, touch Diagnostics to
open the "DIAGNOSTICS" menu (refer to "DIAGNOSTICS" on page 35). On the
"DIAGNOSTICS" menu, touch WIRELESS, then touch Link Quality.
The screen displays the Received Signal Strength at Panel and Received Signal
Strength at Gateway meters, as shown in the following illustration.
"DIAGNOSTICS" Menu (Showing Wireless Link Quality)
Other buttons on the "DIAGNOSTICS" menu should only be used under the
supervision of a Crestron customer service representative during telephone support.
For more information regarding wireless setup, refer to "Appendix A: The RF
Spectrum" on page 57 and "Appendix B: Optimum RF Reception Guidelines"
which starts on page 58.
Touch MANUAL CONFIG to enter the manual configuration menu where it is
possible to change the RF Power and set the RF Channel, as shown in the following
illustration. When using manual configuration, these should be selected to match the
gateway prior to starting the acquire process.
"WIRELESS SETUP" (MANUAL CONFIG) Menu
Isys 5.7" Wireless Touch Screens
Isys 5.7" Wireless Touch Screens: TPS-6X Series • 27