Getting Started; Configuration Wizard; How To Use The Wizard - Strong SRT 5410 User Manual

Getting Started

Once you have connected the
1. Install the batteries in the remote control (see page 10).
2. Turn on the television.
3. Plug the
4. Turn on the
the diagram on page 8).
5. Select the video or AV input channel to which the
by pressing the TV/AV or VIDEO button on your TV remote control. (Refer to your TV user's
manual for instructions.)
The Strong Technologies banner page briefly appears, followed by the installation wizard
(explained in the next section).
Installation wizard
The first time you turn on the
appears. The installation wizard is a set of windows that enables you to easily specify all the
important settings. The first window of the wizard is shown below.

How to use the wizard

• You move from window to window by pressing the blue button on the remote control.
• On most windows, you can step back to the previous window by pressing the smaller of the two
red buttons on the remote control (near the bottom left of the remote control).
• Where a setting has a number of options, it is shown enclosed in angled brackets (as in
<English>). If you need to choose an option other than the one showing, press
option you want is showing.
into mains power and turn on the power at the mains switch.
using the power-on switch on the back of the receiver (number 10 in
(and whenever you reset he unit) the installation wizard
to your antenna and to your television, you need to:
13
is connected: this can be done
or until the