Getting Started; Minimum Set-Up - Strong SRT 5023X User Manual

Digital terrestrial television receiver

Table of Contents

Getting Started

Once you have connected the

preferred video and audio connections, you need to:

1. Install the batteries in the remote control (see page 10).

2. Turn on the television.

3. Plug the

4. Turn on the

diagram on page 8).

5. Select the video or AV input channel to which the

by pressing the TV/AV or VIDEO button on your TV remote control. (Refer to your TV user's

manual for instructions.)

The Strong Technologies banner page briefly appears, followed by the Init Install screen (see

below).

On this screen you choose the language for the OSD (on-screen display) and your country. The

OSD language defaults to English and the country defaults to Australia. If these defaults are

suitable, go to step 9 below. Otherwise, continue with step 6 below.

6. Press VOL

or VOL

is highlighted. Then press OK to select the highlighted language.

7. Press CH▼ or CH▲ to highlight the Area option.

8. Press VOL

or VOL

press OK to select the highlighted country.

9. Press OK. A message appears asking if you want to install.

10. Press VOL

or VOL

The

now automatically scans for digital TV channels and radio stations in your area

and lists them on the screen as it finds them.

to your antenna and to your television with your

into mains power and turn on the power at the mains switch.

using the power-on switch on the back of the receiver (number 10 in the

on the remote control and then CH▼ or CH▲ until the language you want

and then CH▼ or CH▲ until the country you want is highlighted. Then

to highlight Yes and then press OK.

is connected: this can be done

Table of Contents