Strong SRT 5410 User Manual page 35

4. By default, the
watch. If you only want to search for free-to-air channels, press
Mode field to FTA Only.
5. Press the smaller red button on the remote control. The
channels and stations.
6. When scanning is finished, a message appears asking you to confirm that you want to save
details of the channels and stations that have been detected. Press OK to save the details (or
press or to select CANCEL and then press OK to reject the channels and stations).
7. Press MENU to return to normal viewing.
Manual Searching
NOTE: Automatic searching (described above) is suitable in most cases. You might use
manual searching if you have deleted a channel and now want to access it again. In this
case, you would just search for that particular channel.
To avoid a fruitless search, you may want to check the strength and quality of the signal
beforehand. To do so, select Signal Level from the Tools menu and press
channel and frequency of the broadcast you will be searching for appears on the screen.
The bars at the top of the screen indicate the strength and quality of the signal. Poor
strength or quality indicate that it may be difficult to scan for that channel or that the
reception might be too poor for you to comfortably watch the channel.
1. Press MENU on the remote control.
2. If Channel Search is not highlighted in the main menu at the left of the screen, press
it is and then press OK.
The Channel Search sub-menu appears.
3. If Manual Search is not highlighted in the sub-menu, press
The Manual Search window appears.
will search for all channels: free-to-air and those you must pay to
35
or to change the Search
begins scanning for
or until the
or until it is and then press OK.
or until