Programming - Henny Penny PFE-590 Operator's Manual

3-14. PROGRAMMING

3-19
1. Press and hold the FUNCTION button for two seconds.
"REG PROGRAM" shows in the display, followed by
"CODE".
2. Press the code 1,2,3. "SELECT PRODUCT" scrolls
across the display.
If no buttons are pressed, within approximately 1 minute
while in the Program Mode, the controls will revert back
to the Cook Mode.
3. Press the appropriate product button, (1-0), to identify
what product you want to program.
4. "INT1" and "TIME" flashes on the left side of the display.
The right side shows the starting time of the Cook Cycle and
can be changed by pressing the appropriate numbers. Ex:
Press 1,0,0,0 and 10:00 flashes on the right side of the
display, setting the start time at 10 minutes.
5. After the time is set, press and release the FUNCTION
button and "INT1" and "TEMP" flashes on the left side
of the display. The right side shows the starting
temperature and can be changed by pressing the appropriate
numbers. Ex: Press 2,5,0 and "250° F" will show on
the right side of the display, setting the start temperature
at 250° Fahrenheit.
6. After the temperature is set, press and release the FUNC-
TION button and "INTI" and "PRESS" flashes on the
left side of the display. Press any of the product buttons,
(1-0), to turn the pressure on or off.
7. After the pressure is set, press and release the FUNCTION
button and "INTI", "LOAD", and "COMP" flashes on the
left side of the display. The factory preset load compensation
value shows in the right side of the display.
Model PFE- 590/592
703