Lid Operation - Henny Penny PFE-590 Operator's Manual

3-1. OPERATING COMPONENTS (Continued)
High Temperature Limit
Figure 3-1
Air Valve
Filter Drain Pan
Filter Union
Fuses

3-2. LID OPERATION

3-3
This is a safety component that senses the temperature of the
shortening; if the temperature of the shortening exceeds 420°F
(212°C), this control opens and shuts off the heat to the frypot;
when the temperature of the shortening drops to a safe operation
limit, the control must be manually reset by pressing the red reset
button, located under the control panel, in the right, front of the
fryer
Pumps air into the shortening, periodically, to keep the shortening at
a uniform temperature; this only functions when the unit has been
sitting idle for a period of time, and when heating from a cold start
The removable pan that houses the filter and catches the shortening
when it is drained from the frypot; also used to remove and discard
old shortening
When hot shortening is in this pan, use extreme care to
avoid burns.
Connects the filter to the filter pump, and allows easy removal of the
filter and drain pan
A protective device which breaks the circuit when the current
exceeds the rated value
To close lid:
1. Lower the lid until gasket comes into contact with the
frypot and lock the lid in place with the lid latch.
2. Pull lid handle forward until it stops.
3. Lift up on the lid handle until it stops.
4. Bring lid handle out towards you until it stops.
5. Push lid handle down, locking lid in place.
LID MUST BE LATCHED PROPERLY OR PRES-
SURIZED SHORTENING AND STEAM MAY
ESCAPE FRYPOT. SEVERE BURNS WILL RESULT.
Model PFE- 590/592
703