Glossary - Henny Penny PFE-590 Operator's Manual

Pressure fryer
Hide thumbs Also See for PFE-590:
Table of Contents

Advertisement

air valve
airflow switch
blower
breading
burner assembly
(gas fryers only)
burner chamber
(gas fryers only)
burner tubes
(gas fryers only)
carrier
cook cycle
casters
cleaning solution
cold zone
condensation drain pan
cook cycle
cooking load
cool
counterweight
403
G L O S S A R Y
HENNY PENNY PRESSURE FRYERS
a valve that allows air into the filter lines when the pump is on in the mixing
mode on eight head fryers
a switch that senses the amount of airflow coming from the blower; if the airflow
falls below a certain level, the switch cuts power to the gas control valve that
shuts down the burners on gas eight head fryers
located on the rear of a gas eight head fryer, the blower pulls flue gases out of
the flue and provides the proper amount of air to the burner tubes for efficient
combustion
a flour and seasoning mixture used to coat the product prior to frying
an assembly on gas fryers that houses the pilot light which ignites the gas that
heats the fryer
the area on four head fryers in which the gas combustion that heats the
shortening takes place
the tubes in eight head fryers through which heated air is forced to heat the
shortening
a wire frame inside the eight head frypot that holds five racks of product during the
the wheels on bottom of the fryer that allow the unit to roll; casters should be
locked when unit is in use and not being moved; casters may be adjusted to help
level the fryer
an agent used to clean the frypot; see recommended cleaning procedures
an area in the bottom of the frypot where shortening is cooler than the area
above; the zone allows the crumbs to settle without burning
a pan located at the bottom of the fryer that collects condensation from the steam
exhaust system; the pan should be removed and emptied periodically
a programmed cycle that cooks a particular product at a preselected temperature
and for a preselected time
the amount of product cooked during a cook cycle
a preset temperature, usually 250° F (121° C) or less, which can be manually or
automatically switched to, to save the life of the shortening, when not cooking.
the weights shipped with the fryer that, when installed in the counterweight
assembly, enable the eight head fryer lid to lift easily
Model PFE- 590/592
G-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pfe-592

Table of Contents