Henny Penny PFE-590 Operator's Manual page 41

3-15. SPECIAL PROGRAM MODE
(Continued)
403
Reset Usage
1. Press and hold the FUNCTION button for two seconds until
"REG PROGRAM" shows in the display. As soon as "REG
PROGRAM" shows in the display, press and release the
FUNCTION button 2 times until "RESET USE" shows in
display.
2. When "CODE" shows in the display, press 1-3-5. "DAILY
will show in the display, and press any of the product buttons
to reset them to 0.
Factory Presets (F/C, Gas/Electric, Speaker Volume,
Speaker Frequency, Codes, Initialize System)
1. Press and hold the FUNCTION button for two seconds until
"REG PROGRAM" shows in the display. As soon as
"REG PROGRAM" shows in the display, press and release
the FUNCTION button 3 times until "FAC PRESET" shows
in the display.
2. When "CODE" shows on the display, enter 2-9-5-7. "DEG"
and "MODE" flashes in the display. Press any of the product
buttons to toggle from ºF to ºC, and vice versa.
3. Press and release the FUNCTION button and "TYPE"
and "FRYR" flashes in the display. Press any of the product
buttons to toggle from "GAS" to "ELEC", or vice versa.
4. Press and release the FUNCTION button twice, and
"SPKR" and "VOL" flashes in the display. The volume can
be changed from 01 to 10, 10 being the loudest.
5. Press and release the FUNCTION button 3 times, and
"SPKR" and "FREQ" flashes in the display. The frequency
can be set from 100 to 2000.
6. Press and release the FUNCTION button 10 times, and
"INITIALIZE SYSTEM" scrolls across the display. Press
and hold any of the product buttons and the display counts
down from 5. Once the display counts down, release the
product button, and the control sets factory preset param-
eters into the controls.
Before attempting to change the other modes in the Factory
Preset Mode, please call the Henny Penny Technical Service
Department at 1-800-417-8405, or 1-937-456-8405.
Model PFE- 590/592
3-22