Henny Penny PFE-590 Operator's Manual page 39

3-14. PROGRAMMING
(Continued)
403
8. After the load compensation, press and release the
FUNCTION button. "PROP" and "CONTROL" shows on
the left side of the display and the factory preset proportional
control temperature shows on the right side of the display.
9. After the proportional control, press and release the
FUNCTION button. "ALM 1" and "TIME" flashes in
the left side of the display, and the first alarm time shows
on the right side of the display. To change the time the
alarm sounds, press the appropriate product buttons to set
the time. Ex: Press 1,0,0,0. 10:00 flashes on the right
side of the display, which means when the timer counts
down to 10 minutes, an alarm will sound.
10. After alarm is set, press and release the FUNCTION
button. "ALM 1", "SELF-'', and "CANCEL" flashes
in the left side of the display and "YES" or "NO" shows
on the right side of the display. The yes and no can be
toggled by pressing any of the product buttons, (l -0).
"YES" means the alarm tone automatically stops after
several beeps. "NO" means someone must manually
press the appropriate product button to stop the alarm
tone.
11. Repeat steps 9 and 10 for alarms 2 and 3.
12. After alarm 3 is set, press and release the FUNCTION
button. "FILTER" and "CYCLES" shows on the left side
of the display and the filter cycle value is on the right side
of the display. The value is the number of Cook Cycles
that must completed before the control signals the operator
that the shortening needs filtered
Model PFE- 590/592
3-20