Special Program Mode - Henny Penny PFE-590 Operator's Manual

3-14. PROGRAMMING
(Continued)

3-15. SPECIAL PROGRAM MODE

3-21
13. After the filter value is set, press and release the FUNCTION
button. "EOC" and "EXIT" flashes on the left side
of the display, and "COOL" shows on the right side of the
display. The end-of-cycle (EOC), exit point can be set to
COOL, SETP, or FLTR, by pressing any of the product
buttons (EOC). At the end of a Cook Cycle, the controls
can be set to return to: COOL, the setpoint temperature, or
to signal the operator to filter the shortening.
14. After the end-of-cycle setpoint is set, press and release the
FUNCTION button. "HEAD" and "COUNT" flashes on
the left side of the display and a number shows on the
right side of the display. The number on the right, is the
number of head of chicken to be cooked when that product
button is pressed. The number can be changed by
pressing the appropriate product button.
Another product can be programmed while in the Program
Mode by following these procedures:
Press and hold the SCAN button at any time while in the
Program Mode, and the display scrolls "SELECT
PRODUCT". Then press any of the product buttons,
(1-0), and now that product can be programmed.
15. To program second interval, press and release the SCAN
button while in the Time Mode, of the first mode. "INT2"
and "TIME" flashes on the left side of the display. Then
follow the steps above, starting with step 4.
Review Usage
1. Press and hold the FUNCTION button for two seconds until
"REG PROGRAM" shows in the display. As soon as
"REG PROGRAM" shows in the display, press and release
the FUNCTION button 1 time until "REVIEW USE" shows
in the display.
2. "DAILY" shows in the display. Press any of the product
buttons to view the usage of that product. Press and hold the
FUNCTION button to exit Special Program Mode.
Model PFE- 590/592
403