Console Codes - Stairmaster StepMill 7000 Owner's Manual

CONSOLE CODES

There are three groups of console codes which are differentiated according to
function. The first group of codes are customization codes and are used to set
defaults such as units, language, heart rate input type, etc. The second group of
codes are machine status codes and are used to track hours and other general
usage patterns for maintenance purposes. The third group of codes are diagnos-
tic codes and are used for troubleshooting. The following key actions are valid in
each group of console codes:
• Pressing [LEVEL ], [ 1
being accessed.
• Pressing [SELECT] or [LEVEL ] at that point allows you to view all
possible selections. Once in this mode pressing [LEVEL ] backs up
through the selections; pressing [ENTER] then selects that item. If
another test level is available at this point, the [SELECT] / [ENTER]
process is repeated.
• Pressing [ ] [1
• Pressing [CLEAR] exits any of the special access modes.
Custom Codes
[ ^ ] [ 3 ] [ 0 ]
[ ^ ] [ 3] [ 1 ]
[ ^ ] [ 3 ] [ 2 ]
[ ^ ] [ 3 ] [ 3 ]
[ ^ ] [ 3 ] [ 4 ]
[ ^ ] [ 3 ] [ 5 ]
[ ^ ] [ 3 ] [ 6 ]
[ ^ ] [ 3 ] [ 7 ]
[ ^ ] [ 3 ] [ 8 ]
[ ^ ] [ 3 ] [ 9 ]
1. Change the workout time by pressing [LEVEL: ^], [3 , [0]. The console will
display "MAX TIME." Press [ENTER]. The console will then display the
current time limit. Use the keypad to enter the desired time, then press
[ENTER]. For no time limit, press [0].
st
# ], [ENTER] displays what group of codes is
st nd
#, or 2 #], [ENTER ] selects that item directly.
change workout time limit between 5 to 99 minutes
change units (MPH or KMH)
choose type of heart rate input and priority (telemetry
or contact)
- N/A -
choose console language
change contrast on console
- N/A -
- N/A -
- N/A -
reset to factory defaults
7000 PT CONSOLE
Page 27