Customizing Ptz Presets, Patterns And Patrols - HIKVISION DS-7604 Series User Manual

User Manual of DS-7604 Series DVR
3. Select the camera to test in the camera drop down menu.
4. Using the Directional buttons and other PTZ control buttons (Zoom In/Out, Focus In/Out, Iris
In/Out), test the functionality of the PTZ camera. If PTZ camera and protocol supports it, you
may also click the Auto-Scan button to test its function. PTZ controls buttons are shown in Figure
40.
5. If PTZ camera is not working properly, make sure PTZ is connected and configured with the
correct settings under the Serial Settings tab.
6. Click Done to exit and return to the previous menu.

Customizing PTZ Presets, Patterns and Patrols

Your DVR allows you to customize presets, patterns and patrols for a connected PTZ, camera. A PTZ
camera must first be configured before PTZ presets, patterns and patrols can be customized (See
Configuring Basic PTZ Settings on page 49).
To customize PTZ presets:
1. Enter the PTZ Configuration menu, shown in Figure 39 by going to Main Menu > System
Configuration > PTZ Configuration.
2. Select the On Camera Settings tab.
3. Select Save Presets and move the camera to the desired position using the PTZ control buttons.
4. Double-click on a preset number in the upper left corner of the screen. The current position of the
PTZ camera will be set for the selected preset number.
5. To test the newly configured preset, first move the PTZ camera to a different position. Select
Recall Presets and click on the preset number. The camera should move to the location that was
set for the selected preset number.
6. Click the Done button to exit out of the PTZ Configuration menu.
Note:
Only the first 23 presets are shown in the table. To save or recall more presets, click on the "..." button.
Clicking the "..." button will bring up a selection list for presets up to 200.
To customize PTZ patterns:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to Main Menu > System
Configuration > PTZ Configuration.
2. Select the On Camera Settings tab.
3. Select a Pattern Number to set from the drop down list.
4. Click the Record button to begin recording the movement of the PTZ.
5. Move the PTZ to the desired locations using the PTZ control buttons.
6. Click the Save button to save pattern.
Figure 40. PTZ Controls Button
51