HIKVISION DS-7604 Series User Manual page 50

User Manual of DS-7604 Series DVR
2. Select the Serial Settings tab.
3. Select the camera to configure in the camera drop down menu on the upper left of the menu. If all
cameras are to be configured with the same settings, select All Cameras from the list.
4. Configure PTZ settings, including those of Baud Rate, Data Bit, Stop Bit, Parity, Flow Ctrl,
Protocol and Address according to the parameters of the PTZ camera(s).
5. Click the Save button to save current settings.
To test and verify PTZ settings:
1. Enter the PTZ Configuration menu, shown in Figure 39 by going to Main Menu > System
Configuration > PTZ Configuration.
2. Select the On Camera Settings tab. This will open up the On Camera Settings menu, shown in
Figure 39.
Figure 38. PTZ Configuration Menu
Figure 39. PTZ Configuration
50