Customizing Ptz Presets, Patterns And Patrols - HIKVISION DS-7200HVI-ST Series User Manual

3. Select the camera to test in the camera drop down menu.
4. Using the Directional buttons and other PTZ control buttons (Zoom In/Out,Focus In/Out, Iris In/Out), test the
functionality of the PTZ camera. If PTZcamera and protocol supports it, you may also click the Auto-Scan button totest
its function. PTZ controls buttons are shown in Figure 44.
5. If PTZ camera is not working properly, make sure PTZ is connected and configuredwith the correct settings under the
Serial Settings tab.
6. Click Done to exit and return to the previous menu.
7.4 Customizing PTZ Presets, Patterns and Patrols
Your DVR allows you to customize presets, patterns and patrols for a connected PTZ ,camera. A PTZ camera must first be
configured before PTZ presets, patterns and patrolscan be customized (See Configuring Basic PTZ Settings on page 57).
To customize PTZ presets:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to MainMenu > System Configuration > PTZ
Configuration.
2. Select the On Camera Settings tab.
3. Select Save Presets and move the camera to the desired position using thePTZ control buttons.
4. Double-click on a preset number in the upper left corner of the screen. Thecurrent position of the PTZ camera will be
set for the selected preset number.
5. To test the newly configured preset, first move the PTZ camera to a differentposition. Select Recall Presets and click
on the preset number. The camerashould move to the location that was set for the selected preset number.
6. Click the Done button to exit out of the PTZ Configuration menu.
Note:
Only the first 23 presets are shown in the table. To save or recall more presets,click on the "..." button. Clicking the "..."
button will bring up a selection list for presets up to200.
To customize PTZ patterns:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to MainMenu > System Configuration > PTZ
Configuration.
2. Select the On Camera Settings tab.
3. Select a Pattern Number to set from the drop down list.
4. Click the Record button to begin recording the movement of the PTZ.
5. Move the PTZ to the desired locations using the PTZ control buttons.
6. Click the Save button to save pattern.
7. To test out your new pattern, click the Play button. The PTZ should move as itdid during the recording process. You
may click the Stop button at any time toend the pattern. Clicking the Play button again will start playing the PTZ
patternagain at the initial position.
8. Click the Done button to exit out of the PTZ Configuration menu.
To customize PTZ patrols:
Figure 44. PTZ Controls Button
42