Configuring Alarms And Exceptions; Setting Up Motion Detection - HIKVISION DS-7604 Series User Manual

User Manual of DS-7604 Series DVR
7. To test out your new pattern, click the Play button. The PTZ should move as it did during the
recording process. You may click the Stop button at any time to end the pattern. Clicking the Play
button again will start playing the PTZ pattern again at the initial position.
8. Click the Done button to exit out of the PTZ Configuration menu.
To customize PTZ patrols:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to Main Menu > System
Configuration > PTZ Configuration.
2. Select the On Camera Settings tab.
3. Select a Patrol Number to set from the drop down list.
4. Select a Preset Number that is next to the Patrol Number from the drop down list that you would
like to add to the patrol.
5. Click the Add button. The Preset Number will be added to the patrol list.
6. Repeat steps 4-5 until you have included all the presets you would like to have on the patrol.
7. Click the Up and Down button at the bottom of the list to change the order of the presets in the
patrol.
8. To test out your new preset, click the Play button. The PTZ should move through the list of added
presets.
9. Click the Done button to exit out of the PTZ Configuration menu.

Configuring Alarms and Exceptions

Setting up Motion Detection

Set up properly, using motion detected recording will increase the number of days your DVR is able to
record. It will only record relevant events rather than everything, which will also make searching for
events easier.
To set up motion detection:
1. Enter the Motion Detection Settings menu, shown in Figure 41 by going to Main Menu >
Recording Configuration > Motion Detection Settings.
Figure 41. Motion Detection Settings Menu
52